Wide Landing Gear Kit - Spyder3D World
Designed for DJI Phantom V1 and V2: XL-RCP 22.0 Wide landing gear kit. This is a new and improved landing gear to replace the original stock landing gear on DJI PHANTOM V1 and V2 series. It was too narrow and short causing multiple problems that would cause it to tilt over and crash during uneven landing and not enough ground clearance to mount camera between the landing gear. So I decided to design and 3D print a new set of landing gear to solve the mentioned problem for my Phantom drone as described the above title. It has a wider stance that makes it tall. Its stick and rod type design allows it to land anywhere even on uneven ground without being tilted by ground obstacles. Take note that I’m using a Z-modeler to build the 3D parts so it may looked cracked on a 3D viewer. When you print it there should be no problem.