-
Comments
0Sales
0 - Be the first to purchase this product.
Snow Saw handle to replace the piece of heat shrink tubing that served as the original handle on the Life-Link® snow saw. It should be printed in Ninjaflex or a similar elastic filament (the printed handle needs to stretch when installed). The handle is front-back symmetric so the same part can be used for either the left hand or right hand by rotating it. It is not top-bottom symmetric, the slightly wider slot should be used as the top of the handle (it is printed upside down). This was designed to fit the Life-Link® snow saw, but there seems to be more than one version and I’m not sure if it will fit the others. LIFE-LINK® is registered trademark of a company which does not sponsor, authorize or endorse this design.
Release date: | May 28, 2015 |
Last updated: | July 3, 2018 |
License | |
Design Category | DIY, Misc |
Design Tag | 3d printed, 3d printing, 3dprinted, 3Dprinting, Life-Link, Outdoors, snow, Sport, Walter |
Misc Notes |

Offline
There are no comments.