Phone Dock for the Motorola G - Spyder3D World

Item Price

  • Quality checked by Spyder3D World
  • Future updates available
  • Comments

    0

    Sales

    0
  • Be the first to purchase this product.

Dock for Moto G phone. There is a fair amount of friction in the connector so the phone needs to be pressed down instead of just dropped into the dock. Requires the following parts

  • 6-32 set screw, approximately 1/4 inches in length (to hold the cable in place – do not over-tighten)
  • StarTech right angle USB Cable http://www.amazon.com/StarTech-com-Micro-USB-Cable-UUSBHAUB1RA/dp/B003YKX6WC (if you use a left angle cable, you will need to mirror the part.
  • A few inches of 1.75mm NinjaFlex filament for the base (red in the pictures) This design tends to warp when using ABS, I’d recommend a non-warping plastic like PET or PLA.

Instructions: The set screw goes into the hole in the back of the dock, and holds the right-angle connector in place. Be careful to avoid screwing the set screw through the connector, it only needs keep it from moving.

Release date: June 3, 2015
Last updated: July 3, 2018
Invalid taxonomy name. Please correct it from the form editor
License
Design Category
Design Tag , , , , , , , , , , ,
Misc Notes
  • Portfolio:

    5 1 2
    +86

Contact :: Author

Please register or sign in first to contact Walter.

There are no comments.

Processing...
Thank you! Your subscription has been confirmed. You'll hear from us soon.
Get the inside scoop on all things Spyder3D® by signing up for our email newsletter!
ErrorHere