Reduces the noise produced by the system when the pump is operating so that you can have a system in your living room or kitchen.
3Dponics is an open-source initiative, so feel free to download the source files and refine the designs. Share your tweaks and improvements with the Spyder 3D World community and collaborate with other members.
[/two_third]
[one_third_last padding=”0px 0px 0px 0px”]
Spyder 3D World Mods – Original design had the cylinder opening as the base (vertical orientation). Spyder 3D World engineers added a flat base to one side of the cylinder and printed the cylinder in a horizontal orientation. This reduces the amount of bridging required to produce the internal baffles, resulting in a cleaner final print.
Tech Specs
[two_third padding=”0px 0px 0px 0px”][/two_third]
[one_third_last padding=”0px 0px 0px 0px”]
- Filament: Abs
- Print temp: 230-235
- Bed temp: 95
- Nozzle: .4
- Later height: .2
- Speed for infill: 40mm/s
- Speed for perimeter: 40mm/s
- speed for outside perimeter: 35mm/s
- Travel speed: 60mm/s
- First layer speed: 12mm/s
- Flow rate: 100%
- Infill: 20%
Click To View Full System
There are no comments.